Manufacturer: Schletter

Pre-assembled screw-in connector with elevation angle of approx. 13°. Suitable for the FixGrid18 system.

Rear wall cladding for elevated PV systems to reduce wind loads, suitable for the FixGrid18 system.

Rear wall cladding for elevated PV systems to reduce wind loads, suitable for the FixGrid18 system.

A profile connector to slide in for all profiles of the ProLine series. The connector is completely pre-assembled, works without tools and is self-locking.

As an end element for module-bearing profiles of the ProLine series, grey.

As a finishing element for module-bearing profiles of the Solo series, black.

The RapidPro module clamp is the logical further development of the proven Rapid16 module clamp, which has been used millions of times. Due to the variable application, the number of items was drastically reduced without sacrificing the possible applications. All module clamps are equipped with a grounding pin as standard.

The RapidPro module clamp is the logical further development of the proven Rapid16 module clamp, which has been used millions of times. Due to the variable application, the number of items was drastically reduced without sacrificing the possible applications. All module clamps are equipped with a grounding pin as standard.

Support for modules for the FixGrid Pro system. The stepless joint of the support enables the desired module angle to be achieved and can be combined with elevation profiles. Suitable for module orientation upright or landscape and also suitable for large format modules.

The ProLine profile series with matching accessories. Installation with module clamps from the ProLine series and the ProLine click system. Mechanical connection: ProLine click groove at the top, M10 screw channel at the bottom, 30mm x 50mm.

For hanger bolts M10 / M12, loose, aluminum 120 x 60 x 6 mm

The new Rapid SML fastening element was developed for roofs with metal shingles (e.g. Prefa). Compatible with the classic Schletter Solar mounting system and the Schletter ProLine series

Suitable for many types of shingles, cover plate with flexible corrugated tape, direct load application to the rafters, for slate overlaps up to 125 mm (in combination with Rapid2+ Slate125 roof hooks (without shingles)

Fastening screws for components and sheets of metal.

Recommendation: At least 80 mm for roofs that are not paneled, at least 120 mm for roofs with paneling and counter battens!

Square head screw, VA.

The universal trapezoidal sheet metal fastener for steel and aluminum sheeting from 0.5 mm; Pay particular attention to the application instructions! Use e.g. in connection with Solo mounting rail.

SlatePlan can be used on shingle roofs, e.g Bitumen, fiber cement or slate can be used to connect hanger bolt systems. Accessories: see hanger bolts